It's hydroMazing!!

posted Dec 9, 2015, 12:28 PM by Cory Potter   [ updated Jun 8, 2016, 8:59 AM ]

hydroMazing controller and sensor unit kit:

  • Arduino Atmega328 Nano ( this project can be extended using more units.)

  • Expansion Shield (Nano) ( solder 4.7k to pin3/Vcc for Dallas Temp.)

  • DHT21/22 Temperature / Humidity sensor ( solder 10k resistor between Vcc/Data )

  • Photocell Module or photocell soldered to 10k resistor.

  • Water Level Sensor (Float)

  • Liquid Flow Rate Sensor

  • Dallas Temperature Sensor (for nutrient solution temperature) (probably needs a connector)

  • nRF24L01 2.4Ghz Wireless Radio Transceiver module with or without SMA Antenna

  • 433MHz RF Transmitter & Receiver Modules set

  • set 3-5 pack of Wireless Controlled Outlets includes remote

  • customized connector wire kit*

  • PVC Conduit Service Box w/ customized lid

  • heat shrink, flexible split-tubing for wires

  • hydroMazing vinyl decal

hydroMazing remote monitoring unit kit:

  • Arduino Nano ( this project can be extended using more units.)

  • Expansion Shield (Nano)

  • Arduino Uno R3 or clone.

  • LCD w/ buttons Shield ( solder header pins to the bottom of front )

  • Real-Time Clock module (DS3231) ( solder 4-pin male header )

  • Piezo Module or piezo soldered to resistor

  • nRF24L01 2.4Ghz Wireless Radio Transceiver module with or without SMA Antenna

  • customized connector wires*

  • PVC Conduit Service Box w/ customized lid

  • heat shrink, flexible split-tubing for wires

  • hydroMazing vinyl decal


*** AVAILABLE ASSEMBLED & TESTED ***



Comments